Sunday, March 4, 2012

Custom Cooler Radio Construction - Part 4

Part 4 - Antenna and Infrastructure
  1. I used a small hole saw to cut the hole for the antenna
  2. From the inside of the cooler use a large washer to tighten the antenna against
  3. Added small wood blocks at the base of the cooler to prevent the battery from sliding back n forth when the cooler is being rolled
  4. The divider partition is screwed into the block on the bottom of the cooler
  5. The top panel is gets screwed into the top blocks


http://mycustomcoolerradio.blogspot.com

1 comment:

  1. so are the cutting boards sealing water with epoxy or the goop or what??

    ReplyDelete